Body/Exterior

Discovery II Rear Corner Finish Molding Clips - DYC101570L + DYC10031L by Allmakes 4x4

  Part numbers:  DYC101570L-AM +DYC10031L-AM Bumper corner molding clips for Discovery II (1999 to 2004) Positioned on the rear corner of the vehicle above the bumper.  Includes 2-green clips and 1-gray/white clip, enough to reinstall...

1999-2004 Discovery Series II Battery / Jack Cover Quarter Turn Clip Set by Allmakes 4x4

  Part numbers:  DZM100060-AM + DZM100070-AM This quarter turn screw clip + turnbuckle secure the battery cover when locked down.    Fits Discovery II (1999-2004)   NOT for 1999 Discovery 1.   By Allmakes...

Genuine Discovery 1 + Discovery II Rear License Plate Lamp Light Kit XFC500050

  Part number:  XFC500050 The rear license plate lamp becomes corroded over time and eventually fails.  Kit includes: -Lamp/Lens -Gasket seal -Bulb -New Hardware   Fits the following Land Rover models: -Discovery II...

1999-2002 Discovery Series II Hood Release Cable and Handle by Allmakes 4x4

  Part number:  FSE000010-AM Hood release cables commonly become seized and stiff after while.  If you can't get under your hood, it becomes very difficult to keep your vehicle well maintained. This assembly includes the...

Alloy Spare Wheel Lug Nut for Discovery Series II RRD100630

  Part number:  RRD100630 The spare wheel nuts for Discovery II are set apart from the road wheel lug nuts buy a 'domed' cap.   NOTE:  These lug nuts are specifically made for the spare wheels and NOT SUITABLE FOR ROAD WHEELS...

1999-2004 Discovery Series II Battery / Jack Cover Quarter Turn Clip Set

  Part numbers:  DZM100060 + DZM100070 + DYF100690 This quarter turn screw clip + turnbuckle secure the battery cover when locked down.    Fits Discovery II (1999-2004)   NOT for 1999 Discovery 1.   Genuine Land...

Discovery II Rear License Plate Holder Mounting Bracket DRB100390

  Part number:  DRB100390 The rear license plate mounting bracket is designed for North American Specification (NAS) sized license plates only.   Fits the following Land Rover models: -Discovery II (1999-2004)   NOT FOR 1999...

8x20mm Push Rivet Fastener by Allmakes 4x4

  Part number:  ANR2224-AM This push rivet or scrivet is used for several land Rover models to fasten plastic body panels, shields and moldings. Once it is pushed into an aperture, the head sits flat and the inner shaft expands to fasten...

2003-2004 Discovery II Driver Left Front Headlamp Washer Assembly DNH000070

  Part number:  DNH000070 DRIVER/LEFT SIDE front headlamp washer sprayer assembly.  Fits Discovery (2003-2004) with head lamp washers.   Entering your Vehicle Identification Number (VIN) above will ensure you receive the correct...

2003-2004 Discovery II Passenger Right Front Headlamp Washer Assembly DNH000060

  Part number:  DNH000060 PASSENGER/RIGHT SIDE front headlamp washer sprayer assembly.  Fits Discovery (2003-2004) with head lamp washers.   Entering your Vehicle Identification Number (VIN) above will ensure you receive the...

02-04 Discovery Hood Release Cable and Handle FSE000080

  Hood release cables commonly become seized and stiff after while.  If you can't get under your hood, it becomes very difficult to keep your vehicle well maintained. This assembly includes the interior release handle/lever and...

1994-2002 Discovery Head Lamp Adjuster Socket Kit by Allmakes 4x4

  1994-2002 Discovery Headlamp Adjuster Socket Set.  Made by Allmakes 4x4. Each headlamp has a set of three (3) adjuster screws which set into these white plastic sockets on the headlamp. This kit includes the following parts, sufficient for...